|
New member Username: SalmieryMartinsburg, WV Post Number: 4 Registered: May-07 | I have 2 kicker comp 10" cvr's 2 ohm dvc and I have a crappy 200 watt 2 channel amp.. I need a new amp before i install my new subs, what can i use that wont insult the kickers.. pioneer head unit - not sure if that makes much of a difference.. while im at it.. what speakers would you reccomend as well as an amp for them? |
|
New member Username: SalmieryMartinsburg, WV Post Number: 5 Registered: May-07 | oh - 98 ford explorerr -- im pretty sure speakers are 6x9 |
|
Gold Member Username: Nd4spd18Southeast PA Post Number: 2676 Registered: Jul-06 | Dude there are so many choices out there, take a look at this to get an idea of what brands to look at: https://www.ecoustics.com/electronics/products/articles/329117.html |
|
Gold Member Username: JuliobSanto DomingoDominican Re... Post Number: 4645 Registered: Dec-05 | kicker zx 300.1 If you're looking 6x9 and you're tight, check infinity, pioneer revs or so. I'd personally look CDTs, rainbow, Focal.... |
|
New member Username: SalmieryMartinsburg, WV Post Number: 6 Registered: May-07 | U think the 300 will be enough for both of them? how would i wire it then? series or paralell? |
|
New member Username: SalmieryMartinsburg, WV Post Number: 7 Registered: May-07 | bump |
|
Silver Member Username: 04redmach1Columbus, GA USA Post Number: 831 Registered: Mar-06 | For the ford explorer, they are 5x7/6x8's in the doors. As for amp for subs, a DD MB2. Speaker wise, I was very happy with my 6x8 Cadence co ax few years ago. If you would like, shoot me an email, I will help you out with everything and give you a great deal. Kevin lowhz01@yahoo.com |
|
Bronze Member Username: SalmieryMartinsburg, WV Post Number: 13 Registered: May-07 | Just got a great deal on an MTX 6500D so I will be using that for the AMP. I will defiantly be needing new drivers, and coax is better because i only have a 500 W 2 channel amp that may not even function anymore.. How much do you think they would run? also would need a capacitor. |
|
Gold Member Username: CtmikeCt. Post Number: 4488 Registered: Feb-06 | what are the specs of the amp? and no cap. |
|
Bronze Member Username: SalmieryMartinsburg, WV Post Number: 16 Registered: May-07 | RMS Power at 4 Ohms 250 W x 1 RMS Power at 2 Ohms 500 W x 1 Performance Frequency Response 20 Hz - 200 Hz Signal to Noise Ratio 100 dB THD at Rated RMS Power 1 % Crossover / Equalizer Bass Boost With Bass Boost Bass Boost Frequency 40 Hz Low - Pass Frequency 40 Hz - 200 Hz Other Features Input Voltage 12.5 volt MOSFET Circuitry Yes 3 Way Ready No Miscellaneous Product ID 20295211 they are dual voice coil subs so the 500 W will be good http://www.crutchfield.com/learningcenter/car/subwoofers_wiring.html?suboptions= Mono%5F2%2D2ohm%2DDVC&type=mono Thats how i will be wiring them these are the subs http://www.crutchfield.com/S-ra3OYpvmi3R/cgi-bin/prodview.asp?I=2067c10vr2&wm=cl Recommended Sealed Box Volume: * Compact (minimum enclosure volume): 0.8 cu/ft; the woofer can handle up to 300 watts RMS (150 watts per voice coil) * SQ (maximum enclosure volume): 3 cu/ft; the woofer can handle up to 300 watts RMS (150 watts per voice coil) |
|
Bronze Member Username: SalmieryMartinsburg, WV Post Number: 18 Registered: May-07 | bump |
|
Gold Member Username: JuliobSanto DomingoDominican Re... Post Number: 4655 Registered: Dec-05 | MTX isn't bad, if you have the money go for it |