2 JBL W10GTi what amp would be best match?

 

New member
Username: Chburns

Post Number: 1
Registered: May-04
I have recent purrchased two of the GTi series JBL 10" subs which have

Power handling RMS: 600 watts
• Power handling Peak: 3,000 watts
• Cut-out diameter: 9-3/16"
• Mounting depth: 9-1/8"
• Sensitivity: 90dB
• Dual 6-ohm voice coils
Frequency Response: 20Hz ~ 1kHz
Impedance: 3 or 12 ohms
Voice-Coil Diameter: 3" (76mm)

What amp would you all recommend to push them? I have looked at the JBL 1201.1 or 1200.1 as well as several other brands, but would like to know what type you all would think is best. If you could, I would really like to know what type of amp you would recommend for one as well as for both because I still have not gotten the subs in and do not know if I will be able to use both or only one. The subs should be arriving any day now and I will be able to see if I can use both or just one. Thank you very much for your time.
 

New member
Username: Chburns

Post Number: 2
Registered: May-04
Also what is you all's opinion about a JBL BPx1100.1 amp? or what would you all recommend to match these? Thanks
 

New member
Username: Chburns

Post Number: 3
Registered: May-04
also, if I went with jbl, which would be better? the old bp 1100.1 or the new GT 1201.1? and what are the real differences in the two?
 

New member
Username: Chburns

TX

Post Number: 6
Registered: May-04
also, can these 2 speakers handle a JBL BPx2200.1?
 

New member
Username: Chburns

TX

Post Number: 7
Registered: May-04
glass wolf? anyone?
 

New member
Username: Raivun

Post Number: 2
Registered: May-04
hey i really am not sure about much when it comes to car adio systems
Mine is 2 JL Audio 12's in a bass box and a Lightning Audio Fast and Furious 450 watt amp all hooked to my factory car stereo
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us