ok so i have 2 diamond d3 10" and a kenwood 1000w amp, so im woundering how i wire it to make it louder, im just learning about speakers, so i was just woundering how it get them to be as loud as they can.
wire them at 1 ohms! from amp, connect all (+) together... like this: amp (+) to 1st sub 1st coil (+) to same sub 2nd coil (+) to 2nd sub 1st coil (+) to same sub 2nd coil (+) repeat the configuration with all the (-)
WARNING: I didn't bother checking if your amp is 1 ohm stable... so if it's not... you'll either blow a fuse or burn the amp. Be careful. However, if it IS 1 ohm stable... you'll be bumpin as loud as possible with what you've got! Now just use a ported enclosure and you'll be all set.
well right now i have each sub just positive to positive on the amp but on my sub its got like 2 positive and 2 nagative places. i dont no if my amp is able to do like 1 ohms.