Ok, right now I have 2 DigitalAudio 12" subwoofers hooked up to a 2000w 2 ch. Nitro amp. If I crank it up, the amp will go into protection mode. I've been told its because of a low ohm load. So, I think I have the subs wired wrong. The suwoofers are dual 4 ohm, but can be put into 8 or 2 ohm operation. So how should I wire them? The subs are in a sealed box, (each side is sealed by itself) also I have the subs bridged. Thanks!
Which DA's are you powering with this amp? That amp will only feed 600wrms @ 4ohms and a doubt it even does that. If your subs are wired like pic #2, you are probably under powering the subs or your gain is set wrong, weak charging sys., etc... Could be a numerous things causing it to go into protect.
Well, i didn't mess with the wiring today, all i did was put the subs in a bigger box and sat em on top of the back seat and faced em towards the back up at the glass. They hit the lower notes way better, but nothing on the higher ones (i mean nothing compared to the other box which is smaller)
