Wiring Diagram

 

Bronze Member
Username: Thelonegunman

C-Bang, Iowa USA

Post Number: 25
Registered: Jan-07
Does anyone have a wiring diagram to wire 2 amps to 1 sub?
 

Silver Member
Username: Adam_s

15 TC9 Hybrid, RE MT Softparts

Post Number: 634
Registered: Aug-04
There is no specific wiring diagram of how to do it. The only way would be if the amps are strappable or if they are two of the same amps exact same settings one amp on each voice coil. If it is dual VC.
 

Bronze Member
Username: Thelonegunman

C-Bang, Iowa USA

Post Number: 26
Registered: Jan-07
I have 2 California Profile 2400 - 2 Ch 400 watt amps. I want to make it so I can hook them both to one 15' Sub. If that helps?
 

Platinum Member
Username: Rovin

1 12 Atomic ...

Post Number: 10682
Registered: Jul-05
www.bcae1.com has a few diagrams on how to DIY .......
 

Bronze Member
Username: Thelonegunman

C-Bang, Iowa USA

Post Number: 27
Registered: Jan-07
Thanks, it may help.
 

Silver Member
Username: Adam_s

15 TC9 Hybrid, RE MT Softparts

Post Number: 636
Registered: Aug-04
Voice coil config on the sub?
 

Bronze Member
Username: Thelonegunman

C-Bang, Iowa USA

Post Number: 28
Registered: Jan-07
Flat wind coil and dual 2 ohm.
 

Silver Member
Username: Adam_s

15 TC9 Hybrid, RE MT Softparts

Post Number: 639
Registered: Aug-04
I looked and couldnt find any specs on that amp. Do you have a link to the amp? Also I know that a lot of 2 channel amps are only bridgable to 4 ohms. Which means that you most likely would only be able to hook up one amp to the sub.
 

Bronze Member
Username: Thelonegunman

C-Bang, Iowa USA

Post Number: 29
Registered: Jan-07
I don't have a link to the amps. They are a few years old and I really am blind here! Just grasping at straws.
 

Silver Member
Username: Adam_s

15 TC9 Hybrid, RE MT Softparts

Post Number: 641
Registered: Aug-04
Do you have the specs to the amp?
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us