all right i have two cvr 12" subs here are the specs
12" subwoofer Injection-molded polymineral cone Double-stitched, foam-ribbed Santoprene rubber surround Frequency response: 25-500 Hz Power handling: 50-400 watts RMS Peak power: 800 watts Impedance: 2 or 4 Ohms DVC Sensitivity: 86.7 dB Top-mount depth: 6-5/16" Sealed box volume: 1.0-4.6 cu. ft. Ported box volume: 1.75-2.25 cu. ft. 1 year warranty
I got it down to two amps which one should i pick im lookin at a Hifonics BXi 1606D 3200-Watt Brutus Mono Amplifier here are the specs on that
RMS @ 4-Ohm: 1 x 550-Watt RMS @ 2-Ohm: 1 x 1100-Watt RMS @ 1-Ohm: 1 x 1600-Watt Hifonics New Illuminated Heat-Sink Design With Blue LED Light Pumps Hifonics Blue Illuminated Logo Maxxsonics Illuminated "M" End Panel Logo Heavy-Duty Ultra-Fi MOSFETS Highly Efficient Super D-Class Amplifier Circuitry With Oversized MOSFET Output Fully Adjustable Accu-Cross Crossovers ±18dB Variable Bass Equalization @ 45Hz 180° Variable Phase Control (15 to 35Hz) Dash-Mountable Bass Remote Control Included Variable 24dB Subsonic Filter Brutus Pulse Wave Modulated MOSFET EXVP (Exponential Vari-Power Supply) Twin-Turbo Torroid Coil Design HSMD Hifonics Surface Mount Design Balance Line Inputs for our 18-Volt Line Drivers RCA Line Output for Amplifier Daisy Chaining Gold Oversized 2-Gauge Power Connectors Power From The Gods Included Warranty: 1 Year Onlinecarstereo.com warranty. 1 Year warranty from Onlinecarstereo.com implies that repairs must be returned to Onlinecarstereo.com, not the manufacturer. More information can be found in our help section under returns & warranties.
I decided this one because i heard that hifonics rates there amps a lil high so i wanted to buy an amp that has a lil higher power than i need for my teo 400 watt RMS subs and the other amp is a Lanzar 1400D here are the specs on that
SPECS
Mono Block Subwoofer Amplifier 1 Ohm Stable MOSFET Power Supply PWM (Pulse-Width-Modulated) System Double Sided Epoxy PCB Circuit Board Gold Plated RCA Inputs Custom Terminal Block for Speaker Connections Thermal, Overload & Short Protection Remote Bass Control Soft Turn On/Off 500 Watts RMS Power into 4 Ohms 800 Watts RMS Power into 2 Ohms 1000 Watts RMS Power into 1.3 Ohms 1300 Watts Max Power into 1.3 Ohms THD @ 1Watt/4 Ohm: 0.1% S/N Ratio: 90dB Frequency Response: 15Hz - 150Hz (+/-3dB) Damping Factor @ 20Hz/4 Ohms: 400 Variable Low Pass Filter: 50Hz-150Hz, 24dB/Octave Variable Subsonic Filter: 15Hz-40Hz, 24dB/Octave Variable Bass Boost: 0 to +18dB Phase Shift Control: 0 to 180 Input Sensitivity: 200mV ~ 8V Input Impedance: 10k Ohm Line Output Impedance: 100 Ohm Fuse Rating: 30A x 4 Dimensions: 10.08'' (W) x 2.12'' (H) x 14.96'' (L)
Will some one please help me pick an amp so i can get a system in my SUV.
well if u alredy have the cvr's then get the lanzar amp and run it off 2 ohms so each sub gets 400rms. if you havent bought the subs yet i wouldnt go with kicker but thats just my preferance
those models are very close in output. If i were you... i'd grab the best deal. I think lanzar optidrive line has better quality than hifonics brutus line. Try running those subs at 1 ohm and set the gain low