I have a P3001 (2 ohm) amp and a 4 ohm P2 12" subwoofer. Where i hook up my speaker wires on amp there is two channels... + - + -. How do i wire the sub, can i just use the left side posite negaative?????, hw would i wire this up?
bernyMAC: It's a mono amp, of course you can't bridge it.
col: Your amp is really one channel (mono). On a lot of mono amps there are two sets or terminals so that you can hook up two subs easily. Connecting two subs, one to each set of terminals, would be the same as wiring them in parallel. Since you only have one sub, just use one set of terminals. If your sub is 4 ohm the amp will put out 150 watts RMS.