Kicker KX 800.2 Help

Jonez788 Silver Member Username: Jonez788 Post Number: 135 Registered: Jun-04	Posted on Tuesday, June 06, 2006 - 04:39 GMT Right now I currently have 2 12" DVC 4 ohm subs hooked up to my Kicker KX 800.2. These are the only specs I could find on it. Kicker KX 800.2 200 watts RMS x 2 at 4 ohms 400 watts x 2 at 2 ohms 800 watts x 1 in bridged mode Right now I'm running the two subs in bridged mode. I'm looking to upgrade my subs and wanted to get the Diamond Audio TDX D9 15" However, I don't know what ohm version I need. DVC 4 or DVC 2? I know I can get the DVC 2 ohm version wired to a 4 ohm load, but it won't be bridged like the specs on the amp say. I believe the Kicker 800.2 does 800 watts x 1 @ 4 ohm. But, I don't know if it matters when it says "bridged mode" after it. What do I need to do to get 800 watts out of that amp to 1 sub? Any help is greatly appreciated.
rick ross Bronze Member Username: Rick_ross Post Number: 43 Registered: May-06	Posted on Tuesday, June 06, 2006 - 18:09 GMT get the dvc 2 ohm sub and wire it to 4 ohms and bridge it on the amp
Jorge Sanchez New member Username: Jsaudio4 Anaheim, Ca US Post Number: 3 Registered: Jun-06	Posted on Tuesday, June 06, 2006 - 21:45 GMT BEFORE YOU BUY ANYTHING FIND OUT MORE INFO ON THAT AMP YOU NEED TO KNOW IF IT WILL DO 4, 2, OR 1 OHM MONO TO PUT OUT ALL ITS 800 WATTS THEN YOU WILL KNOW WHAT SUB TO BUY
Jonez788 Silver Member Username: Jonez788 Post Number: 140 Registered: Jun-04	Posted on Tuesday, June 06, 2006 - 22:41 GMT I know, that's what I'm asking and Rick Ross did a nice job of answering it. 800 watts X 1 @4 ohm. With the positive speaker wire going to the positive on the left channel. And the negative speaker wire going to the negative on the right channel. Correct?
rick ross Bronze Member Username: Rick_ross Post Number: 45 Registered: May-06	Posted on Tuesday, June 06, 2006 - 22:48 GMT yea that sounds right
ty mutlow Gold Member Username: Tjmutlow Post Number: 2195 Registered: Sep-05	Posted on Wednesday, June 07, 2006 - 00:31 GMT same power if you run it 2ohm load stereo, also you can not get 2 dual 2 ohm to a 4ohm load. if running bridged, use the dual 4 running series/paralal wiring. i personally would just run it stereo mode

« Previous Thread Next Thread »

Main Forums

Forum Help

Follow Us