Bronze Member Username: Aman2005
Post Number: 59
Registered: May-06
|
Posted on Any one know how to connect two type X subs to this amp? wIll this amp work with them?/
Average Power Output/CH into 4 Ohms, 4 Channels Driven @10Hz~40kHz, 0.5% THD 85W X 4 or 170W X 2
@1kHz, 10% THD 250W X 4 or 500W X 2
Low Pass Filter (VARIABLE) 40Hz ~ 150kHz
High Pass Filter (VARIABLE) 80Hz ~ 1.2kHz
Output of Bridged (BTL) Operation into 4 Ohms @ 1kHz, 1% THD 1000Watts
Frequency Response (-1dB) 10Hz ~ 40kHz
Signal to Noise Ratio ("A" WTD) >100dB
Input Sensitivity 100mV ~3V
Input Impedance 22k Ohms
Operation Voltage (Negative Ground) DC 12V
Speaker Impedance @ Stereo Driven 4 Ohms
Fuse Rating 40A X 1
Dimension (WxHxD)mm 260X58X320
|
Gold Member Username: Theelfkeeper
Stockbridge,
GA
USA
Post Number: 2191
Registered: Feb-05
|
Posted on whats the VC configuration for your subs??
also, 170 watts will not be enough to push thoes subs. |
Gold Member Username: Tjmutlow
Post Number: 2096
Registered: Sep-05
|
Posted on AMP WONT WORK, YOULL BURN IT OUT AN NOT ENOUGH POWER.... |