4 channel amp question

johnny lemoine Silver Member Username: Johnnylemoine LaPlace, Louisiana United States Post Number: 786 Registered: Aug-04	Posted on Tuesday, May 02, 2006 - 03:13 GMT if i have a four channel amp, can i run a 2 ohm load to one set of channels, and a 4 ohm load to the other set? i have one set of components that are single 4 ohm and the other set is single 2 ohm. there shouldnt be a porblem, right?
ty mutlow Gold Member Username: Tjmutlow Post Number: 1962 Registered: Sep-05	Posted on Tuesday, May 02, 2006 - 10:14 GMT as long as you do not use the 2 ohm bridged your ok.
johnny lemoine Silver Member Username: Johnnylemoine LaPlace, Louisiana United States Post Number: 790 Registered: Aug-04	Posted on Tuesday, May 02, 2006 - 14:00 GMT ok man, thanks. i figured there shouldnt be a problem, but my freind said he ran his like that and it went into to protect a few times. musta been a different problem. ok thanks again ty.
Isaac Gold Member Username: Carguy Post Number: 5518 Registered: Nov-04	Posted on Tuesday, May 02, 2006 - 14:46 GMT If the amp goes into protection mode, it means it's either not 2ohm stable or the gain/level wasn't set correctly.
johnny lemoine Silver Member Username: Johnnylemoine LaPlace, Louisiana United States Post Number: 791 Registered: Aug-04	Posted on Wednesday, May 03, 2006 - 01:48 GMT ok kool, thanks isaac. im pretty good at setting gains, i just wanted to make sure before i commit to buy these XXX components. they are single 2 ohm, right? thats wut the ebay description said. 1.8 actually
ty mutlow Gold Member Username: Tjmutlow Post Number: 1968 Registered: Sep-05	Posted on Wednesday, May 03, 2006 - 09:58 GMT RUN THEM IN STEREO MODE, ONE SIDE PER CHANNEL

« Previous Thread Next Thread »

Main Forums

Forum Help

Follow Us