Ok, just want to make sure before i have it setup.
I have 2 amps, 1 for the sub and 1 for my mids -arc audio 1500-xxk -ppi a600.2
I have a 1/0 lead coming from the battery for my power and also have a distribution block that i can use that is 1/0 in and two 4,8 outs.
I have a 1 farad cap but im not sure that i want to use it because of all the extra wiring and cuts.
The main ground is under the rear seat where the seat connects to the chassis and is done real tight and clean with no paint.
How can i wire this up the right way for the grounds specifically. Should i just run amps grounds to the same location as the original ground under the rear seat or in differant places ?
Im going to work on this so help me out step by step. Thanks
If the ground under your seat is solid, then use that to run 0 gauge wire into d block. From d block, connect 4 gauge wires to the amps. Install the cap with 12" wires on Arc. Ground loops can occur if the amps or HU have different grounding points.