|
New member Username: CelliniBurlington, Wa U.s. Post Number: 1 Registered: Mar-06 | Im having trouble with this amp here http://cgi.ebay.com/PERFORMANCE-TEKNIQUE-1200W-MONOBLOCK-MONO-AMPLIFIER-AMP_W0QQ itemZ9703319307QQcategoryZ18797QQssPageNameZWDVWQQrdZ1QQcmdZViewItem The protection light keeps coming on. i have it wired putting out a 2 ohm load to a performance teknique 12in 4ohm dvc 1000 watt sub. it will play at a very low volume but if you turn it up it will cut out very quickly. can anybody give me any advice???? |
|
Gold Member Username: TheelfkeeperStockbridge, GA USA Post Number: 1501 Registered: Feb-05 | check your gains, grounds, wire size, voltage when it cutts off... |
|
New member Username: W0ntonjaiPost Number: 2 Registered: Mar-06 | how can you check the voltage? |
|
Bronze Member Username: SweatyogrePA USA Post Number: 16 Registered: Mar-06 | Volt meter |
|
New member Username: CelliniBurlington, Wa U.s. Post Number: 2 Registered: Mar-06 | What would i be looking for when im checking the voltage when it cuts out? |
|
New member Username: CelliniBurlington, Wa U.s. Post Number: 3 Registered: Mar-06 | Ok, i think the problem was my ground. I've switched it around about 3 times and my stereo has played stronger each time. where would the ideal place be for me to ground my amp? do i need to scuff the paint off where i hook my ground to so it will conduct better? and will a good ground effect the ohm load my amp can handle in any way because it says its stable at 2ohms but it go's into protection when i wire it that way. |
|
New member Username: CelliniBurlington, Wa U.s. Post Number: 4 Registered: Mar-06 | ......................... |