|
Silver Member Username: Terps297Potomac, MD USA Post Number: 144 Registered: Oct-04 | 2 Phoenix Gold Xenon amps to a Digital Designs sub which is Dual 4 ohm. |
|
Gold Member Username: RovinTrinidad & T... Post Number: 6198 Registered: Jul-05 | Post models nos of each ... |
|
Silver Member Username: Terps297Potomac, MD USA Post Number: 145 Registered: Oct-04 | DD 3515 D4 Phoenix Gold Xenon X600.1 (x2) |
|
Gold Member Username: RovinTrinidad & T... Post Number: 6204 Registered: Jul-05 | my post did not bump ...... |
|
Silver Member Username: Terps297Potomac, MD USA Post Number: 146 Registered: Oct-04 | huh? |
|
Silver Member Username: Terps297Potomac, MD USA Post Number: 147 Registered: Oct-04 | bump |
|
Bronze Member Username: Scott_debakerPittsburgh, P.A. U.S.A. Post Number: 98 Registered: Feb-06 | if that amp does 4ohms stable brigded i guess u can run 1 amp 2 each 4ohm vc |
|
Silver Member Username: Terps297Potomac, MD USA Post Number: 149 Registered: Oct-04 | ok, but how would i wire the amps, like the rca's and other cables, do i just hook up each amp to a voice coil? and everything esle is the same? |
|
Silver Member Username: Scott_debakerPittsburgh, P.A. U.S.A. Post Number: 102 Registered: Feb-06 | get sum rca spliters or a cross over an get a distrution block for the power wire an spice other remote off the old 1 an make a ground right where the other 1 is an u only run wire from the channel of the amp 2 the voice coils liek speaker wire an u just cant wire each amp 2 a voice coil right yet them amps gota be 4ohms stable briged so u wont fry ur amps or hurt the sub if the amps are 4ohm stable briged ull be fine get the specs of the amps |
|
Gold Member Username: RovinTrinidad & T... Post Number: 6267 Registered: Jul-05 | good read 4 u http://wickedcases.com/tutorials/index.html |
|
Silver Member Username: Terps297Potomac, MD USA Post Number: 150 Registered: Oct-04 | the amps are like jl's where they sense the ohm load...so i should be fine i guess |
|
Silver Member Username: JohnnylemoineLaPlace, Louisiana United States Post Number: 588 Registered: Aug-04 | i wired 2 orion 1200D's to my XXX 12, it was kinda complicated. i had to run a wrie from the neg on the slave amp to the neg on my master amp and switch the slave amp to 180 degrees out of phase and run pos terminals to the neg on the sub and on the master amp run the pos terminals to pos on the sub. each amp had 2 negs and 2 pos terminals. and as for rca's i just ran a short rca from the pass through on the master to the input on the slave. marshall can prolly explain it a lil better, he helped me hook it up. but we just followed wut the manual said. |