|
New member Username: MangleLynchburg, VA USA Post Number: 3 Registered: Mar-05 | I have four 4ohm DVC MB Quart subs what is the best way to wire them there are 2 pos and neg terminals on each sub. I will be using a Kenwood KAC9102D to power them with. They are going in a quad enclosure non ported. Will be in the back of a 2004 trailblazer. |
|
Gold Member Username: Chaunb3400Huntsville, Alabama U.S. Post Number: 5239 Registered: Jul-05 | U can wire it to a 2 ohm or 8 ohm load, what are the specs on ur amp |
|
Gold Member Username: Chaunb3400Huntsville, Alabama U.S. Post Number: 5240 Registered: Jul-05 | http://www.the12volt.com/caraudio/woofer_configurations.asp |
|
New member Username: MangleLynchburg, VA USA Post Number: 4 Registered: Mar-05 | Thanks for the info Chauncey Brown here are the Amp specs 1,700 watts max output Mono amplifier 850 watts RMS @ 2 ohms 2 Ohm stable 500 watts RMS @ 4 ohms Efficient Class D Circuitry MOSFET Power Supply Noise Suppression Filter Copper Power Transformer Dual Secondary Caps Detachable Top Panel for Controls Die-Cast Alluminum Heat Sink Advanced Low Pass Crossover 18 dB / Octave Subsonic Filter Preamp Outputs High and Low Level Inputs Screw-Type Power and Speaker Terminals 0-18 dB Bass Boost @ 90 Hz Single-Side Terminal Placement for a more efficient install Frequency Response: 5-200 Hz Signal to Noise Ratio: 100 dB Dual Cooling Fans |
|
New member Username: MangleLynchburg, VA USA Post Number: 5 Registered: Mar-05 | This is probably not the best and most high end equipment but I am on a budget. I have almost a total of $400.00 in the box subs and AMP all new stuff. Found a deal and took it I hope it will be good enough for a starter set anyway I will see how it sounds in a week or so. |
|
Gold Member Username: RovinTrinidad & T... Post Number: 5443 Registered: Jul-05 | good of u 2 give the amp specs - but where r the specs 4 ur subs !???.............. |
|
New member Username: MangleLynchburg, VA USA Post Number: 6 Registered: Mar-05 | 10" Subwoofer Impedance:4 Ohm DVC Frequency Response: 16- 300 Sensitivity: 2,8dB Power Range: 400 Watts Recommended Box 1 (Vb): 0.65 cu. ft. sealed |