I have two Alpine SWR 1222d (dual 2 ohm) powered by an Hifonics BX1605d. Would I be able to wire the r's separate from each other and run two different wires to my amp rather than one? The hifonics has two different speaker input's so i was thinking of just putting the two jumpers in each separate sub and wire them directly to the amp, rather than putting only one jumper in a - and + terminal of both subs and wiring them together which is how i have them now.
It says in the alpine diagram i can wire the dual 2 ohms to 1 ohm by placing both jumpers in each sub and then just run a - and + wire to the amp. The amp will let two subs be wired separately but it says "2 ohms each minimum"
So all i need to know is this ok to do or should i stick with how i have them now, wired together?
"""Rovin..i posted this earlier, whats your opinion?"""
u can get by with it if u wire ur subs to it @ 2ohms
its rated 1100wrms @ 2ohms in reality its roughly around 800wrms
even though a R is rated @ 500wrms it handles 600 cause there r alot of ppl on this forum pushing 2 of em (4ohms version) with either a orion/kicker 1200 amp & no problems . The JBL GTO1201.1 is known 2 be better than the Hif amp - so either use what u got or sell it on this forum cause a few of those have sold here & ppl will buy it .......