Now the HU settings for sub levels should i leave thoes at 0 or could i turn them up just a bit to push the amp a bit harder?
Right now i have everything no at max but not at zero so about at 80% of the way and amp gets reallllyy hot after about 15 min of listening.
So im guessing i should turn down the amp gain from like 90% to about 85? Also my HPF and LPF on my HU is LPF:80 and HPF:180 now on the back of the amp its like 25% gain for LPF and like 80% gain for HPF do thoes settings go together? Also is the SQ Setting at 60Hz+6 good. So ya thanks id love for the suggestions thanks.
LPF HPF and LEVEL then it has a switch for Freq its at LOW but options are High and another one i forget. Im guessing thats for Subs with bass or stickly sound or both.
500RMS at 2ohm X 2 300RMS at 4ohm X2 1200 Bridge at 4ohms x1
SUbs Dual VOice Coil 4 ohms per voice COil 500RMS per and 1000watt max.
So i got two sets of terimnals. Neg Neg and Pos Pos from there i got a neg and pos going to the box terminal and then from ther ei have a neg and pos going into channel 1 and then same thing for other sub into channel 2. So from what i know im running the amp at 500RMS at 2ohms because thast how it was wired to be but i wouldnt know so how does that sound? Now for the HU settings how should i set the in terms of Sq Set and the Freq and stuff? Should everything be up 1 notch + in terms of Sub Level its at +2db and my bass boost notch is about 3/4 the way when i want it to bump hard or well all the way up if im showing off lol. SO any suggestions/?