Hey, anyone know if any of these wiring configurations have any advantage over the next? They're all wired paralell, just in different ways. Dont think it really matters, but I'm using a HiFonics 1605D powering six 8ohm subs all wired in parallel. (1.33 ohm load final - one input per box, wired internally)
Anyways.. Was wondering which of these setups would be the most efficient, as far as sound goes? Or does it even make any bit of difference at all? Just curious.. I know they all = the same resistance, etc, just wondering if there's any advantages or disadvantages to certain methods.
So, of the three.. A B or C?? (If it does, in fact, matter. If it dosnt, just disregard this question, of course.)
B. All the subs will be getting equal amount of wire resistance. Therefore, 12 gauge would work just fine. In case of A, one pair of wire is trying to supply all 1600w rms. C is the same.
