|
Silver Member Username: Sony224422Deep River, CT US Post Number: 210 Registered: Dec-04 | Okay, so i have two 2+2 ohm subs. Im going to wire them so they present one ohm each, equaling two. Do i wire them so that they are each one ohm and then run them to my amp? My amp has two outputs for speakers, but its a mono class d amp. Mtx thunder 801d. would this do what i need it to do.. which is present a 2 ohm load for my amp? |
|
New member Username: Who_cares_1Post Number: 2 Registered: Sep-05 | wire the voice coils in parallel and then the subs in series. that should give you an impedance of 2 ohm |
|
Silver Member Username: Sony224422Deep River, CT US Post Number: 211 Registered: Dec-04 | you mean the voice coils in series and then the subs in parallel |
|
New member Username: Who_cares_1Post Number: 4 Registered: Sep-05 | wait... r the subs dual 4 ohm, or 2 ohm? |
|
Silver Member Username: Sony224422Deep River, CT US Post Number: 212 Registered: Dec-04 | i have two terminals on my box.. i want to use them both, and present a 2 ohm load to my amp. how would i go about doing this? |
|
Silver Member Username: Sony224422Deep River, CT US Post Number: 214 Registered: Dec-04 | dual 2 |
|
New member Username: Who_caresPost Number: 1 Registered: Sep-05 | ok then ya.. ur right, oops. wire the voice coils in series and then the subs in parallel |
|
New member Username: Who_cares_1Post Number: 5 Registered: Sep-05 | ok then ya... ur right, oops. wire the coils in series and then the subs themselves in parallel |
|
New member Username: Who_cares_1Post Number: 6 Registered: Sep-05 | lol, stupid account |
|
Silver Member Username: Sony224422Deep River, CT US Post Number: 215 Registered: Dec-04 | right but should i wire the subs in series and then to the box and put it on one output, and do the same for the other one on the other out put? |
|
Silver Member Username: RovinTrinidad & T... Post Number: 903 Registered: Jul-05 | CHECK THIS http://www.the12volt.com/caraudio/woofer_configurations.asp |
|
Silver Member Username: Sony224422Deep River, CT US Post Number: 216 Registered: Dec-04 | haha i know how to wire them to get the ohm load i need, i just don't know if the way i want to connect it to my amp if it will get the right load. I know that im going to wire them to one ohm each, and then run each of them to the two outputs on the amp. I think it will give me the right load, since it will be 2 ohms on the one channel, since class d amps are only one channel.. even if they have more than one output spot. |