AMP PROBLEMS

 

New member
Username: Red_alert05

Post Number: 2
Registered: Jul-05
I had a 1500 boss rtd amp wired at 4ohms and puttin out 540 watts rms. While about 2-3weeks after I had it hooked up I was riding down the road and my subs cut off. I thought a fuse might have blown so i checked the amp and the protection light was on then it would go off and pop right back on at the same time the subs tried to play but couldn't. could somebody give me an answer to this Please thankyou
 

Silver Member
Username: Iowahawks19

Post Number: 344
Registered: Jun-05
check the ground
 

Gold Member
Username: Glasswolf

Wisteria, Lane USA

Post Number: 8794
Registered: Dec-03
gain may also be set too high, causing the amplifier to clip at higher output levels, and go into thermal protection mode.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us