How big is the amplifier? How many amps does it draw, it should list it in the specs. The generator may not pass enough amps to run the amp and could make it send out a clipped signal, which is bad for your amp and speakers.
please help, I want to hook two 2ohm DVC speakers and one 4ohm DVC speaker together to one mono amp. want to be between 2 and 3 ohm load if possible. Can you please tell me how to wire the. thanks much
i'm having a problem with my car audio system...i have a crossover and an amp going to 2 12's...when i start my car i get this loud noise for about 3 seconds then it goes away...after my car is started up the car comes back about a minute later...i noticed that it sounds like my engine only amplified through my subs...well, one of my subs..one sub is playing as normal but the noise coming from the other sub overshadows that one...i also noticed that when i step on the gas the noise comes back if it has gone away... please help
I was wondering what the diagram looked like for a wireharness for a pioneer DEH-P3500?, my red wire came out of the harness and i am not sure what port to put it back into.