|
Bronze Member Username: QcsfinestPost Number: 41 Registered: Jun-05 | Ok. I talked to a guy at a local car place to see what kind of amp I should get for my 2 12"w6v2's. they are 400rms each. I was going to buy the 1000/1 but he said that is to much since its in a ported box. He recomended the 500/1. What do you think? |
|
Gold Member Username: GlasswolfWisteria, Lane USA Post Number: 8735 Registered: Dec-03 | well, if you're going ported, the enclosure will limit excursion, and somewhat decrease mechanical power handling so yeah the 500/1 would be fine. Save ya money, too. That'd work. |
|
Bronze Member Username: QcsfinestPost Number: 42 Registered: Jun-05 | Ok. well right now I have an Autotek 750.1. If the 500/1 will work, will this amp work. I havent tried it, its been sitting in my closet |
|
Bronze Member Username: QcsfinestPost Number: 43 Registered: Jun-05 | http://www.carreview.com/cat/car-audio/amplifiers/autotek/PRD_31121_1806crx.aspx #reviews |
|
Bronze Member Username: QcsfinestPost Number: 44 Registered: Jun-05 | ? |
|
Gold Member Username: GlasswolfWisteria, Lane USA Post Number: 8744 Registered: Dec-03 | depends on the coil setup for the specific subs. |
|
Bronze Member Username: QcsfinestPost Number: 45 Registered: Jun-05 | ok im lost on that one... but i know the subs are wired up at 1.5ohms |
|
Gold Member Username: GlasswolfWisteria, Lane USA Post Number: 8747 Registered: Dec-03 | then stick with the JL amp. it's rated 1.5 ohm stable and puts out the same power regardless of load. you have 3 ohm subs. |