|
Bronze Member Username: Shadow1290Post Number: 37 Registered: Jul-05 | http://www.onlinecarstereo.com/CarAudio/CompareItems.aspx?CompareItems=14487,144 809 What in the hell is the real difference between these two speakers Plus, what the hell does it mean |
|
Silver Member Username: Bnd_rulezPhoenix, AZ USA Post Number: 641 Registered: Mar-05 | Your link don't work too good. |
|
Bronze Member Username: Shadow1290Post Number: 45 Registered: Jul-05 | Manufacturer Infinity /Infinity Model Perfect10 VQ /Perfect10d VQ Title 10" Component Subwoofer with Variable Q (Each) /10" Dual 4Ohm Component Subwoofer with Variable Q (Each) Ave. Rating Not Rated Yet Diameter 10 Inch/ 10 Inch Low Frequency response 25 Hz /25 Hz High Frequency Response 400 Hz /400 Hz Sensitivity 87 dB /87 dB Impedance 4 Ohm /Dual 4 Ohm RMS Power Range 75-400 Watts /75-400 Watts Peak Power Handling 1600 Watts /1600 Watts Price $209.00 /$209.00 opy and past didnt work to well but the "/" seperate the two speakers featuress try this link one more time http://www.onlinecarstereo.com/CarAudio/CompareItems.aspx?CompareItems=14487,144 89 it should work (It does on mine) |
|
New member Username: Jekz409Post Number: 5 Registered: Jul-05 | basically the difference is the OHMS which is pretty obvious... its basically personal preforance depending on how your system is going to be wired. |
|
Silver Member Username: ScubasteveAnnapolis, MD Post Number: 203 Registered: May-05 | they're both the same sub, just with 2 different wiring configurations. If you're getting two, go with the 10 vq. If you're getting 1, go with the 10d vq. both of these configurations wired in parallel will result in a combined load of 2 ohms. |
|
Bronze Member Username: Shadow1290Post Number: 47 Registered: Jul-05 | i was just confused with that i knew that one was SVC and one was DVc but they were the same price is what really screwed me up usually SVC's are like double the price |
|
Bronze Member Username: Shadow1290Post Number: 48 Registered: Jul-05 | DVC's double the price sorry Typo |
|
Silver Member Username: ScubasteveAnnapolis, MD Post Number: 207 Registered: May-05 | double the cost? that strange, the only extra cost of making a DVC version of an SVC sub is the new set of terminals and the tinsel leads (and maybe a little bit more labor). |
|
Bronze Member Username: Shadow1290Post Number: 51 Registered: Jul-05 | y exactley i was just kinda exaggerating to get my point across Cause their the "exact" Price down to the cent |
|
Silver Member Username: ScubasteveAnnapolis, MD Post Number: 212 Registered: May-05 | haha alright, my bad |
|
Bronze Member Username: Infinity_addictSanta Rosa, California USA Post Number: 18 Registered: Jul-05 | thiele-small peram. diffs, straight from the manny... 10VQ/10dVQ Sensitivity @ 2.83V/1m: 87dB/90dB Voice-Coil DC Resistance Revc: 3.32 ohms/1.66 ohms Voice-Coil Inductance Levc: 1.2mH/.8mH Motor Force Factor BL w/LowQ Insert: 15.05/11.5532 w/MidQ Insert: 13.05/9.33 w/No Insert: 10.49/8.1 Compliance Volume Vas: 1.61ft 3 (45.88 L)/1.32ft3 (37.65 L) Suspension Compliance Cmd: 309.68uM/N|254.13uM/N Moving Mass, Air Load Mms: 153.44g/157.9g Moving Mass, Diaphragm Mmd: 150.1g/154.56g Free-Air Resonance Fs: 23.09Hz/25.13Hz Mechanical Q Qms: 9.67/10.24 Electrical Q Qes w/LowQ Insert: .33/.31 w/MidQ Insert: .44/.46 w/No Insert: .68/.61 Total Q Qts w/LowQ Insert: .32/.30 w/MidQ Insert: .42/.44 w/No Insert: .63/.57 |