I was wonderin i was going to wire my 2 10" 4 ohm (200 watt rms, 450 watt max-per speaker)Rockford Fosgate punch stage 2 speakers one speaker to each channel
but i noticed that it has 500 watts at 4 ohms vs. 200 watt x2 at 4 ohms, my question is should i wire them each speaker to one channel or bridge them and wire them in parallel for a 2ohm load??
Sony Xplod Specialty series 1200 watt amp * Amplifier Type: 2-channel * RMS Power @ 4 Ohms: 200W x 2 * THD at 4-Ohm RMS Power: 0.008% * Bridged RMS Power @ 4 Ohms: 500W x 1 * Speaker Level Inputs: Yes * Preamp Outputs: Yes * Built-In Crossovers: LP * Bass Boost: 0 - 10 dB * Frequency Response: 5-50,000 Hz * Signal to Noise Ratio: n/a * Fuse Rating: 2 x 40 amps