|
Silver Member Username: AraknidBOCA , FL U.S. Post Number: 816 Registered: Nov-04 | Remember a while back i was helping my friends brother put together a system and you said we needed a different sub, well it turned out alright we got the right sub and whatever but i remember you saying this. "when you bridge a two channel amp, the amplifier will see half of the actual load" Can you explain in more detail of what type of amps this applies to and say an amp says its 4 ohm stable, isn't that indirectly saying it would be 2 ohm stable then? because then if it was 4 ohm stable then you would need an 8 ohm load.? |
|
Silver Member Username: Audiobass10Cape Coral, FL United States Post Number: 144 Registered: Jul-05 | http://www.bcae1.com/ Check out section 51. |
|
Gold Member Username: GlasswolfWisteria, Lane USA Post Number: 8112 Registered: Dec-03 | what he said. I'd just be saying the same thing Perry said on BCAE already in the bridging section. bridged rules apply to any bridged multichannel amplifier. |