New member Username: Markstanco
Texas
Post Number: 6
Registered: Jul-05
|
Posted on I about have it narrowed down here and wanted some opinions.
Putting the RF P212S4 Subwoofer in a ported box
adding the RF P3001 Mono and the P3002 for the highs.
Should this sound fine? |
New member Username: Elusive_peanut
Knoxville,
TN
Post Number: 7
Registered: Jul-05
|
Posted on I wouldn't put a mono amp on a 4 ohm sub unless you are satisfied with getting half the rated power from the amp (or you are going to run two subs).
Put a p3002 on the P212S4. |
New member Username: Markstanco
Texas
Post Number: 8
Registered: Jul-05
|
Posted on Just picked it all up late this afternoon. I upgraded a bit. 
RF T112D4 rated at 600 watt RMS for the woofer
RF P6001bd for the mono amp
P 2502 for the highs on 4 speakers at 2 ohms.
I know, it looks to be base heavy but you would be surprised how sound from under the floor is muffled through fiberglass (dont know why but it is). |
Bronze Member Username: Big_oso
Post Number: 64
Registered: Jun-05
|
Posted on mark i have a good amp for them subs ill sell you cheap a rf p5002 its warrentied through 08 let me know if your interested itll run 500 rms @4ohm |
New member Username: Markstanco
Texas
Post Number: 10
Registered: Jul-05
|
Posted on cant handle the 500 RMS. Speakers are Marine grade Clarion. I am thinking they are either 100 or 150W speakers.
Will be upgrading to MB Quart Marine next week more than likely. Clarion is decent, by the MBQ's suuuure sound nice! |