|
Bronze Member Username: JaackdethBurnett, WI United States Post Number: 82 Registered: Sep-04 | I have 2 amps. one is a phoniex gold 501, and the other a hifonics 1500 mono for subs, is 4 gauge power wire enough for both? Or what should I be using? |
|
Bronze Member Username: ScubasteveAnnapolis, MD Post Number: 63 Registered: May-05 | how much total current draw? |
|
Bronze Member Username: JaackdethBurnett, WI United States Post Number: 87 Registered: Sep-04 | Well the Phoniex is about 60x4 and the hifonics is running 2 L7 10" subs at 1 ohm at the amp! Were you talking what it needs rms? |
|
Gold Member Username: InvainMichigan United States Post Number: 2949 Registered: Aug-04 | Definitely go 2 or 1/0 gauge. |
|
Bronze Member Username: JaackdethBurnett, WI United States Post Number: 88 Registered: Sep-04 | For ground to? |
|
Bronze Member Username: JaackdethBurnett, WI United States Post Number: 89 Registered: Sep-04 | And what kind is good? Do they make a flat cable that gauge? Thanks!! |
|
Bronze Member Username: ScubasteveAnnapolis, MD Post Number: 81 Registered: May-05 | flat 2 awg or 1/0 cable, not that i know of, it would probably be like a foot wide. Look at Knukonceptz for your wires. http://www.knukonceptz.com/productMaster.cfm?Category=Amp%20Installation%20Kits# And you'll need some distribution blocks as well. |
|
Bronze Member Username: JaackdethBurnett, WI United States Post Number: 90 Registered: Sep-04 | Ok, thanks!! I seen some flat wire somewhere, if I find it, I will post it. I believe it was 4 gauge however! |