how do these two amps compare to each other. which one would be more efficient (draw less current). which one would be better for sq and have more quality...???
The only real significant difference is the price. The JBL is a fraction of the cost and has just about as good build quality. It depends on what you are powering, that would give it more SQ. I would take the JBL.
Current draw should be about the same on both amps. like sub said, the JL will prolly sound a lil better...but you could get 2 maybe 3 bp1200.1's for the price of 1 JL 1000/1.
Dont under over look the bp1200.1...its a great lil amp.
You must have HO alternator in your car right? I whould run it to my avalanche but i already have the jl 500/1 to use. I may just end up gettin it later on when i upgrade to a HO alternator cause i like the price on this jbl amp.
Hey MO if I were you I would sell that 500/1 and buy a HCCA 250G4 and run the Avalanche at 1ohm thats what I am gonna do as soon as I get a minute to take out my A600 and hook up the 250G4, I cant stand looking at this thing in my room it is killing me. Hey Isaac do you think I should run my A/D/S's with my a600 and have no rears or should I run them with my pcx 480 and run my rear boston acoustics with it? I cant wait to get this done I just cant really make up my mind what I want to do, I am getting the Components installed on the 19th so I have to know what amp I want to run to them by then.
an HCCA250g4 on that Avalanche would be really nice. I think it is fused at 60A.
Here is what it is rated at: 2 x 50 @ 4 Ohm 2 x 100 @ 2 Ohm 2 x 200 @ 1 Ohm 2 x 400 @ .5 Ohm 1 x 200 @ 4 Ohm 1 x 400 @ 2 Ohm 1 x 800 @ 1 Ohm these amps are underrated though.
wow that is flexible. Nice amp. I could always use my ppi pcx2200 later on when i upgrade to HO alternator which is a nice amp for my avalanche also and that amp is 80A and it reads like this for ratings: 200 x 2 @ 4ohms 400 x 2 @ 2ohms 800 x 1 @ 4ohms
I could use this for my avalanche 15 but how do i wanna wire this to get the right voicecoil and wattage from the amp.
MO you can use that amp. Wire it in series for a 4ohm load. I would go with that over the 500/1. The fuse rating on the 250hcca is 80 amps not 60amps. I would run either one of those two amps but since you already have the PPI run that
