ebr6965 Unregistered guest | how would i hook up 2 12'' audiobahn "dub 200" dual 4 ohm coil to an audiobahn A8002t amp. The subs are:RMS (Continuous): 1,400 watts Per Pair / 700 watts Each Sub 2 ohm or 8 ohm operation the amp specs are: 2X200w RMS @ 4ohms 2X400w RMS @ 2ohms 1X800w RMS @ 4ohms Class A/B MOSFET power amp 2 ohm stereo stable 1/2/3 channel operation (mixed Mono) My friend already hooked up the amp but doesnt know how to hook the subs up correctly. i was wondering if someone could draw me a diagram or tell me where i could get one on how to hook them up |
Silver Member Username: Davids2004Houston, TX USA Post Number: 769 Registered: Jun-04 | http://rockfordfosgate.com/rftech/wiringwizard/2_4ohmDVC_4ohm.gif |
Silver Member Username: Davids2004Houston, TX USA Post Number: 770 Registered: Jun-04 | wire the subs like above and bridge the amp. |
New member Username: Rcmaniac01Rutledge, Tennessee Usa Post Number: 2 Registered: Apr-05 | take an wire the subs parallel / parallel that will take the load down to 1ohm make sure your amp is 1ohm stable or just go to |
Gold Member Username: JmloughreyFarmington, CT Post Number: 1110 Registered: Jul-04 | that amp is 4 ohm stable bridged and 2 ohm stable stereo...i know, i had one....wire each sub to 2 ohms since they are dual 4...run each sub off its own separte channel....no need to bridge the amp and make it run that much hotter... |
New member Username: Rcmaniac01Rutledge, Tennessee Usa Post Number: 3 Registered: Apr-05 | you could bridge the subs to 8ohms each then bridge the together to the amp for a 4 ohm load |
Gold Member Username: JmloughreyFarmington, CT Post Number: 1112 Registered: Jul-04 | ...but why bridge an amp when you dont need to? its just gonna run hotter then it really has to...and beleive me...that amp gets hot...the little cooling fans dont do much....as hunter can attest to, i modded the cr@p out of mine |