Need wiring help

 

New member
Username: Jbrozi

Post Number: 1
Registered: Mar-05
I Need help to wire this equipment up for the best and safest sound. I've all ready toasted the amp once! I have the following equipment.
Sony xplod cdx-m610 HU
(1) Audibahn 15" DVC 4 Ohm sub 500 watts RMS
Lanzar Vibe-251 2 channel 1600 watt amp
2 X 250 watts RMS at 4 Ohms
1 X 1000 watts max at 4 Ohms Bridged
2 X 450 watts at 2 Ohms
2 Ohm stereo stable..

Any help in this matter would be GREAT!!
Thanks
 

Bronze Member
Username: Byrumjr

Post Number: 100
Registered: Jan-05
If the amp does what they say. I see two ways I would do it. Hook each channel to each voice coil on the sub. That will get you 250 rms to each coil and 500 rms to the sub. Or you can wire the sub at 2 ohms and just hook up to one channel. This will give you 450 rms to the sub.
 

New member
Username: Jbrozi

Post Number: 2
Registered: Mar-05
Can you bridge it at 8 Ohms? Or is this not recommended..
 

Bronze Member
Username: Joe_c

Oakwood, Ga

Post Number: 11
Registered: Mar-05
i agree w/ jbrozi, series it out at 8 ohms pos from amp to pos on one side of vc neg on same side og vc to pos of other vc then finally neg of vc back to neg on amp
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us