Wiring dvc subs

jonathan ramirez New member Username: Blindmp2 Post Number: 5 Registered: Feb-05	Posted on Monday, February 28, 2005 - 03:47 GMT i have 1200Q audiobahn and 2000 watt performance teknique and i dont know how to wire, i tried but he amp went into protection and i dont know how to get the amp out of proteciton
Joe Smoe Gold Member Username: Invain Michigan United States Post Number: 1001 Registered: Aug-04	Posted on Monday, February 28, 2005 - 03:51 GMT You probably don't have the ohms matched up and the amp goes into protection. Is the audiobahn dual 4 ohms?
jonathan ramirez New member Username: Blindmp2 Post Number: 6 Registered: Feb-05	Posted on Monday, February 28, 2005 - 03:55 GMT yes they are
Subfanatic Silver Member Username: Subfanatic Walton, Ky Post Number: 487 Registered: Dec-04	Posted on Monday, February 28, 2005 - 03:58 GMT then wire it to 2 ohms like this...pos to pos...neg to neg on the coils...then another speaker wire from one of the pos's to the pos on the amp...same with the neg's, do it as if you were doing it as bridged and bridge the amp
jonathan ramirez New member Username: Blindmp2 Post Number: 7 Registered: Feb-05	Posted on Monday, February 28, 2005 - 04:01 GMT its a two channel amp though
Subfanatic Silver Member Username: Subfanatic Walton, Ky Post Number: 489 Registered: Dec-04	Posted on Monday, February 28, 2005 - 04:02 GMT you should be able to bridge it...let me go find it and tell you
Joe Smoe Gold Member Username: Invain Michigan United States Post Number: 1004 Registered: Aug-04	Posted on Monday, February 28, 2005 - 04:03 GMT Is it bridgeable? If it's not then you could run each voice coil to a channel. You'd have to be careful with it like that, make sure the gains are set exactly the same.
jonathan ramirez New member Username: Blindmp2 Post Number: 8 Registered: Feb-05	Posted on Monday, February 28, 2005 - 04:04 GMT i dont know if its brigable it said bridgable with other amp thoough, if it is how should i wire it
nick Bronze Member Username: Nnnnick_b Nc Usa Post Number: 58 Registered: Jan-05	Posted on Monday, February 28, 2005 - 04:04 GMT alot of amps cant bridge into 2 ohms, just run a channel on each coil and it should be fine.
Joe Smoe Gold Member Username: Invain Michigan United States Post Number: 1006 Registered: Aug-04	Posted on Monday, February 28, 2005 - 04:07 GMT If it is bridgeable then it will most definitely be in 4 ohms, which won't work with your sub. Wire each voice coil to a channel.
jonathan ramirez New member Username: Blindmp2 Post Number: 9 Registered: Feb-05	Posted on Monday, February 28, 2005 - 04:12 GMT alright then

« Previous Thread Next Thread »

Main Forums

Forum Help

Follow Us