|
New member Username: Bdb_86Post Number: 9 Registered: 12-2003 | i have 2 8" crunch usa 190w 4ohm speakers i get that if i wire them in series i get 8ohms right but if i wire them in parallel then what well the ohms be? |
|
Anonymous | you will get a 2 ohm load if you wire them parallel..... what you will need is a 2 channel amp that matches the RMS of the subs as close as you can match it and wire one sub to each channel. this will be a 2 ohm sterio load. |
|
Bronze Member Username: Bdb_86Post Number: 11 Registered: 12-2003 | ok lets say i had 4 of these speakers and i wire 2 of them in parallel and the other 2 the same and put one set on the right channel and the other on the left channel, i have a 150x2 rms 4ohm crunch amp well this hurt the amp any or hurt the sound |
|
Silver Member Username: Its_bacon12Post Number: 104 Registered: 12-2003 | well if you have 4 of these 8 inch speakers, you will run the 2 channel amp at 2 ohms to each channel, and get probably 2x the RMS power output to each channel giving each subwoofer 150w RMS.... it will not "hurt the sound or amp" by your words, it only gives the amplifier a higher power output and possibly less damping factor too |
|
Gold Member Username: GlasswolfPost Number: 1005 Registered: 12-2003 | http://www.bcae1.com/ohm.htm |