I just purchased two brand new Rockford Fosgate P210s4's (punch 2's not 1's ten inch). I have a RF p2002 amp. I dont know if my amp will be enough to power those two p2's so if glasswolf or someone can tell me if i will be alright as far as power goes. Thanks in advance.
the subs are 200 w rms and 400 w peak power and my amp is a RF p2002 but im not sure exactly how much rms watts to each channel im running, and doesnt ohms have something to do with how much each subs gets?
Rockford Fosgate Punch P2002 MSRP $190.00 US Channels 2 Per channel power CEA-2006 compliant 50 W x 2 @ 4 Ohms RMS 100 W x 2 @ 2 Ohms RMS 200 W x 1 @ 4 Ohms Bridged RMS Total power 200 Watts Bridgeable Yes Crossover HP 40-400Hz 12dB per Octave LP 40-400Hz 12dB per Octave Tone controls Bass Control 0 to 18 dB @ 45 Hz Signal input Low level - Quantity - 1 Type - RCA(pr) Line output 1 RCA(pr)
Phase control Power input Connector - Block
Wire gauge - 4 Speaker output Block Power supply topology Output topology Display Heatsink Type -Cast Protection Remote control Included Type - Wired Controls - Bass Class A/B Marine use Specifications Stereo/Mix mono Frequency response 20 to 20k Hz +/- .5 dB Dimensions 2.4 X 11 X 11.7 (inches)
even at 2 ohms, you'll only get 199w x 2. that's not really enough power. how many coils and ohms per coil for each sub?
I cant tell you. I dont have the subs here i put them on lay away until i sell my other subs. I just need to know if i have to have a new amp to run these subs.