|
New member Username: Mdale007Post Number: 1 Registered: Oct-04 | I upgraded my '04 Altima head unit to a new Alpine CDA-9833 with the i-Personalize. My question concerns the Xover settings for the following stock speakers. The rear 6 X 9's (Xover to -3db 80hz 24db/oct) The front 5-1/4 and tweeters (Xover to -3db 125hz 12db/oct) If I am correct these Xover settings should prevent distortion? I do not understand phasing and I do not have a sound meter. I would like to know if these settings especially the slopes are correct? |
|
Gold Member Username: GlasswolfNorthWest, Michigan USA Post Number: 4561 Registered: Dec-03 | that's about where I'd set them myself. looks good. leave phase at -0 (zero) |
|
New member Username: Mdale007Post Number: 2 Registered: Oct-04 | GlassWolf thanks for the information concerning leaving the phase a -0. Can you direct me on how to use the 5-Band Parametric EQ? |
|
Gold Member Username: GlasswolfNorthWest, Michigan USA Post Number: 4584 Registered: Dec-03 | I can show ya a page on parametric EQs and what they do.. how to set the Alpine's is all in the manual for the unit. it takes a little fumbling to get used to setting it, but a parametric is set-and-forget. once it's set you leave it alone. http://www.bcae1.com/equalizr.htm |
|
New member Username: Gstern1994Post Number: 2 Registered: Jan-05 | Thanks a million guy's, had the same questions about my 9833. Sounds Terrific now. |