|
Anonymous | I was wondering about the qaulity and power of Phoenix Gold amplifiers. Would it be a good idea to go with a R5.0:1 mono amp for two earthquake tens rated 220 watts each? |
|
Silver Member Username: Koz1031Monticello, In United states Post Number: 131 Registered: Jul-04 | Did you get the db series? |
|
Silver Member Username: Koz1031Monticello, In United states Post Number: 132 Registered: Jul-04 | just slightly overpowering them. but you should be ok. i believe you will have to run those subs in parallel to get them down to 2 ohm. as that amp is 2 ohm http://www.phoenixgold.com/2004/octane-ramps.html |
|
Anonymous | Yes I have the DB10's 220 watts rms. Isn't this amp rated 400 watts rms at 2 ohms so wouldn't this be slightly underpowering them? |
|
Silver Member Username: InsearchofbassPost Number: 603 Registered: Jun-04 | phoenix gold makes good stuff but the octane series is ok but the tantrum stuff is better also check out the mtx stuff its cheaper than the phoenix gold stuff (mtx 1501d or the mtx 81000d) |
|
Silver Member Username: InsearchofbassPost Number: 604 Registered: Jun-04 | whoa wait this is for two 10s 220 watts each man also i didnt realize the octanes rating was peak |
|
Silver Member Username: InsearchofbassPost Number: 605 Registered: Jun-04 | youd be fine with the octane on those 10s like koz said |
|
Anonymous | I hear that MTX are pretty good amps. Would they be comparable to the Xenon series from PG or the Kicker KX400.1? How do these three amp manufacturers compare to one another? Thanks |
|
Silver Member Username: InsearchofbassPost Number: 606 Registered: Jun-04 | they are all pretty close in performance to each other |
|
Anonymous | alright then thanks for the help |
|
Silver Member Username: InsearchofbassPost Number: 608 Registered: Jun-04 | your welcome |