Can Someone help me - to get american channels back- I have CW600s -Dish Pointed with 61.5,110 and 119. Right now iam getting channels only from 61.5. I tried scanning for 110 and 119, I did not get any american channels. Can Someone tell me what TP settings i have to use...
Satellite-61.5 Transponder -12326/H/20000/Auto LNB Freq-11250 LNB Type -Normal 22khz-Auto Diseqno-LNB1
Satellite-110 Transponder -12516/V/20000/Auto LNB Freq-11250 LNB Type -Normal 22khz-Auto Diseqno-LNB2
Satellite-119 Transponder -12384/H/20000/Auto LNB Freq-11250 LNB Type -Normal 22khz-Auto Diseqno-LNB3
Before it was working perfectly when technnician installed. Once i had a problem with Reciever - I reset to Factory setting i Lost all settings made by technician, Only i can recover 61.5(LNB1) settings and channel.For LNB 2 & LNB3 i tried by different settings doesn't seems to help. The above are current settings in the reciever.
ok for 110 change tp freq to 12224 and for 119 change tp freq to 12457 and you will see quality pop up and correct satellite will pop up on top right hand corner
Sam, if that does not fix the problem then i need you to do this. turn receiver off,go outside to switch and swap out port 1 and 2 now go inside turn receiver on, of you have lost 61.5 and 110 is on,then you have a blown switch.get a new chieta heavy duty switch. before you replace the switch make sure to switch receiver off from back and this time hook up satellites as follow 119 > port 1 110 > port 2 61.5 > port 3 then turn receiver on and adjust antenna settings by assigning 119 > lnb 1 110 > lnb 2 61.5 > lnb 3
ok, go ahead and write down antenna settings for all 3 satellites and do factory reset then do hard reboot go back in and adjust antenna settings and scan all three satellites