New member Username: Cswminty
Tamworth,
Staffs
UK
Post Number: 8
Registered: Nov-06
|
Posted on I have a black (with a faint Grey line down it) that runs from the intellistart to under the bonnet.
Only when fitting the wiring loom back into the car i am unsure as to where that wire connects to.
I have a connector that is on the fuel injector, is it that it connects too???
any help would be greatly appreciated.
Thanks
Chris. |
New member Username: Cswminty
Tamworth,
Staffs
UK
Post Number: 9
Registered: Nov-06
|
Posted on i think i found it on a wiring diagram
BLACK/GRAY - RPM Input
but what would it connect to under the bonnet on a scooby?? |
New member Username: Cswminty
Tamworth,
Staffs
UK
Post Number: 10
Registered: Nov-06
|
Posted on i think i have found it again.....
H2/12--black/gray rpm input
This wire monitors the RPM of the vehicle during remote start sequence.
Connect this wire to the vehicle coil's negative side or the non-common fuel injector wire. |