well it's long story, bref: HH90 motor with Invacom 4 head LNB fortec ultra receiver. now the question : INSTALLATION and wiring diagram: the 4 head are C L C L , L: for linear sat 121, and C: for 119, 110 . how to connect ? do i need 2 wire from the LNB L and C to Switch 2x1 ? if so what will be the configuration on the receiver menu? if not , then how? Thank for anybody can help
From Invacom LNb go out two cables 6' each to disque switch, let say from L to port 1 and from C to port 2 , then you go out to yours motors and out to receiver,
Dish Net/BEV Settings These settings are the same for: Echostar 3 (61.5), Nimiq 2 (82), Nimiq 1 (91), Echostar 6,8 (110), Echostar 7 (119), Echostar 1, 2 (148), and Echostar 4 (157). LNB Type = Standard LNB LocalFreq. = 11250 22KHz = Off DiSEqC = set as desired LNB Power = On 0/12V = 0 Volt TP = 12224 v 20.000 Positioner Setting = Set as desired (if no HH motor, select DISABLED) Scan = All For AMC2 (105) and Echostar 9 (121), use the following settings (assuming you have the correct type of LNB): LNB Type = Standard LNB LocalFreq. = 10750 22KHz = Off DiSEqC = set as desired LNB Power = On 0/12V = 0 Volt TP= 11720 (for 105) or 11724 (for 121) Positioner Setting = Set as desired (if no HH motor, select DISABLED) Scan = All
hi i yet look my fortec ultra to nimiq1 powerscan it, channesl came but after saving and tune them my receiver stops working only black screen after turning off and on works again with 110 and 119 still any idea