Just got Matrix RSX 3.5 and there were no Antena/CU cable. Is it possible to make it at somehow ? Is there straight/cross connections ? Is it shielded cable ? Thanks in advance.
Ps1k0, Why ? The problem is here in nearest 3000 miles no any Clifford reps. Is there something specific in that cable ? It suppose to be 4-PIN (2 wires antenna power supply, and 2 wires for signal transmition LF control signals. RF part modulators and reciever/transmitter in antenna itself) so why do u think home made cable wont work ? I check ground wire that pin 2 on antenna and CU. So it should be straight then. Just to be 100 shure could you please tell me PIN-out of cable and is it straight or crossed somewhere. Original cable cost something about 2 USD i don't think there are something "unic" and specific.
homemade cables may work just fine. as long as you are "OK" with burning out your alarm.
the only problem is that it's a two-way antenna (it sends and recieves) so it's more than just a wire (like the older alarms)
I wish I could help more with the pinout's for it. but i don't have access to that information.
hmm.. clifford is made by DEI so the antenna might be compatiable with the Viper brand. if you have a viper dealer nearby you might be able to try them for one of theirs. you could also try any local install shop and see if they have some kind of connection that could get/order one.