1. Home
    2. >
  2. Forum
    3. >
  3. Car Audio Forum
    4. >
  4. Car Subwoofers Forum
    5. >
  5. Archive through July 06, 2005 Forum
    6. >

Wiring MTX4250 Amp to UL-D612 Sub (6ohm)

 

Dougy
Unregistered guest
Posted on   
Trying to connect,
MTX 4250D Thunder Mono Amp.

Key Features
Amplifier Type Mono Channel
Bass Boost With Bass Boost
Bridgable Not Bridgable
Power Output
RMS Power at 2 Ohms 250 W x 1
RMS Power at 4 Ohms 125 W x 1
Performance
Frequency Response 20 Hz - 200 Hz
Low - Pass Frequency 40 Hz - 200 Hz
Signal to Noise Ratio 100 dB
Bass Boost Frequency 40 Hz
THD at Rated RMS Power 1 %

Other Features
Input Voltage 12.5 volt
MOSFET amp Yes
3 Way Ready No

And

ULTRA LINEAR ULD612 12" SUBWOOFER


* 450W RMS
* 900W Max
* Dual 6 Ohm Voice Coil
* Double Stacked Magnet



* Die Cast Basket
* Butyl Rubber Surround
* Sensitivity: 87 dB @ 1w/1m
* Frequency Response: 25Hz - 3kHz


Is this possible plain and simple...Readin Ohm law as u read.


Option 1 (parallel) = 3 ohm load
Voice coils wired in parallel
Recommended Amplifier: Stable at 2 or 1 ohm mono




Option 2 (series) = 12 ohm load
Voice coils wired in series
Recommended Amplifier: Stable at 4, 2, or 1 ohm mono

Which wiring option would u picked with my sub/amp.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us